Agency Power 17-19 Ford F-150 Raptor 3.5L EcoBoost Cold Air Intake Kit AP-RAP-110
AP Cold Air Intakes
Engine Cold Air Intake
A cold air intake kit for the Ford F-150 2.7L or 3.5L EcoBoost is one of the first upgrades you should do to your truck. The twin turbocharged engine that powers the F-150 and the Raptor will benefit from the improved intake design giving you an overall better driving experience. The Agency Power cold air intake kit gives your EcoBoost better throttle response, allows the turbochargers to spool up quicker, as well as increase torque along with horsepower throughout the entire RPM range. As you go through the 10 speed transmission, you will hear the turbochargers spool up as they take in a much larger volume of air. When the driver is not heavy on the throttle, you can even expect a slight improvement to your MPG. As tested on a stock 2018 Ford Raptor running 91 octane while using our Mustang Dynamometer, the intake made a peak gain of 10 rear wheel horsepower (rwhp) while maintaining a midrange of 12rwhp. Torque jumped up 20ft per lbs over stock giving you more power off the line and when you need it most! Agency Power's intake design and manufacturing is all done here in the USA. The custom high flow cone filter has a large 5.5 inch diameter flange taking in air from 360 degrees around. To further improve air flow, even the front of reusable air filter is designed to pull in air from its concave top. The filter has been designed to sit in a lightweight and OEM looking roto molded intake box embossed with the AP logo. The box design has been engineered to integrate with the factory air snorkel. The air filter is sealed off from hot engine air with a rubber gasket that is mounted to the one piece box. Connecting the air filter to the two turbochargers is a one piece, roto molded intake tube that splits off with a clean seamless merge. With this design, the Agency Power intake tube flows over 100 percent more air than the stock intake tube. The intake is finished off with an integrated sensor mount, AP silicone couplers, and required hose clamps.